Replies
- CU
Mar 5, 2018You might have a ring thats too small (because your balls can never be too big!) but what I do is first put the ring over the cock shaft down to the balls. Then if its a tight ring I'll start by pulling one ball through. Usually thats not too bad. Then you need to pull and push the second ball through. Sometimes I'll grab the "bag" and pull that through first and then push the ball through.
Its a little hard to explain, much easier to show in person.ReactReply - CUMar 6, 2018
You might have a ring thats too small (because your balls can never be too big!) but what I do is first put the ring over the cock shaft down to the balls. Then if its a tight ring I'll start by pulling one ball through. Usually thats not too bad. Then you need to pull and push the second ball through. Sometimes I'll grab the "bag" and pull that through first and then push the ball through.
Its a little hard to explain, much easier to show in person.ReactReply - SA
Mar 19, 2018Normally slip balls through the ring first then ease my cock through.
Sometimes one ball will slide back up insides me, so just take ring off and start again.ReactReply - KI
Mar 26, 2018Try putting a little lube on the ring. I find it helps if it is a tight fit.
ReactReply - MEMemberMar 27, 2018
A warm shower with soapy water does wonders on removing them. It should work on the install side.
Later,
ReactReply - NI
May 22, 2018The most common cockring sizes in US measurements are 1.75, 1.875 and 2" diameter. Larger and smaller are available. If you ever travel near a store that sells them they will usually let you try them on. If you have large balls you may need a bit larger size than will fit tight against your abdomen. The usual technique is to push one ball through then the other ball and penis last. Best if you are flaccid. An alternative is a cockstrap, hich is more like a belt, snaps easily surrounding the whole package.
ReactReply